Flight attachment for severe service in two strand and multiplie chain strand conveyors, runs over chain sprockets and plain chain wheels with and whithout groove, made from MnCr-steel, forged and case hardened, highly wear resistant, welding area prepared for welding to flight bar, simple assembly and disassembly on the slack chain, suitable for reverse operation
Stick electrode:
ISO 3580: E Mo B
EN 1599: E Mo B 4 2 H5
AWS A5.5-ASME II/C, SFA5.5: E 7018-A 1
Surface finish: shotblasted-oiled
Sprockets for use with HV and DSZ-round steel chains with replaceable and adjustable individual teeth, made from MnCr alloyed steel, case hardened - highly wear resistant. Sprockets are welded steel fabrications, any number of teeth or hub design is available. Keyways are machined in the hubs of matched wheels to ensure precise alignment of the teeth. Hub design, bore diameter and key size can be specified by the customer. Shimplates can be fitted to adapt the pitch circle dia. of the sprocket to a chain lengthened due to wear in the interlink points of contact. This ensures continued smooth running of the chain over the sprocket and the maximum use of the case hardened layer in the chain. Shimplates and new teeth can be mounted without disassembly the chain.
Chain couplings for individual chain lengths HV and DS. The chain couplings have the same technological characteristics as the corresponding highly wear resistant chains. Pay attention that the couplings should be assembled and installed according to the instructions included in the packaging. These couplings can only be mounted as vertical links. Run as vertical links over sprockets, plain and grooved wheels.
Surface finish: shotblasted and waxed.
